Just-better Disabling Auto Shut-Off Instrukcja Użytkownika Pobierz pdf (Strona 1)

Diabling Auto Shut-o Feature

ATLAS is set to automatically shut-o after 30 minutes if the weight reading does not change during

that time. This feature can be disabled through the following procedure:

NOTE: Before attempting to disable the auto shut-o, verify the software version of your particular scale, as

the instructions dier slightly depending on the software version installed. Verify the software version by

powering up the scale and observing the display at start up. The software version will be shown as the scale

initializes. Turn the scale o and proceed as follows based on the installed software version.

1. FOR VERSIONS 1.01 and 1.02:

With the scale o, press the zero button (leftmost button) and the unit selection button (middle

buttone) at the same time. While pressing these two buttons, also press the power button (rightmost

button). The scale should power on and display “ ATLAS version X.XX” briey, then display a weight

reading with “TEST MODE” below it.

FOR VERSION 1.03 and higher:

With the scale o , press and hold down the unit selection button (middle button), then press the

power button (rightmost button). The scale should power on and display “ATLAS version X.XX ” briey,

then display a weight reading with “TEST MODE” below it.

All remaining instructions are the same regardless of software version:

2. Press the unit selection button to toggle through the test mode options. The third option will show

“AUTO OFF= YES”.

3. Quickly press the zero button once; the display should now say “AUTO OFF= NO”.

4. Press and hold the zero button to save this setting and exit test mode. You will see the words “TEST

MODE” disappear. Once the scale exits test mode, only the weight reading will be displayed. You can

now use your scale with the auto shut-o disabled.

If you wish to enable the auto shut-o feature again at some point, repeat the above procedure and

change the setting to display “AUTO OFF= YES”.

JB Industries

Aurora, IL 60507

800-323-0811

www.jbind.com

Updated 2008

Diabling Auto Shut-o FeatureATLAS is set to automatically shut-o after 30 minutes if the weight reading does not change during that time. This feat

Brak uwag

Just-better Disabling Auto Shut-Off Instrukcja Użytkownika Strona 1